Managing the AP
Enabling Other Management Access Options
Ruckus Wireless Indoor AP 100.2.0 User Guide, 800-70892-001 Rev A 168
Telnet Port This field lists the default Telnet port of 23 — only if Telnet is active.
You can manually change this port number, if required.
SSH Access By default, this option is enabled (active).
SSH Port This field lists the default SSH port of 22—only if SSH is active. You
can manually change this port number if required.
HTTP Access This option is disabled by default.
HTTP Port This field lists the default HTTP port of 80, if HTTP has been
activated. You can manually change this port number if required.
HTTPS Access By default this option is enabled. This connection mode requires a
security certificate, a copy of which has been pre-installed in the
device.
HTTPS Port This field lists the default HTTPS port of 443—only if HTTPS has
been activated. You can manually change this port number if
required.
Certification
Verification
This notes whether the security certificate linked to the HTTPS
settings has been passed or not.
Controller
Discovery Agent
(LWAPP)
• Enabled (default) -- Lightweight Access Point Protocol controller
discovery on. (Refer to
Release Notes for details.)
• Disabled -- LWAPP controller discovery off.
Cloud Discovery
Agent (FQDN)
• Enabled (default) -- Fully Qualified Domain Name cloud discovery
on; requires enabled LWAPP controller discovery Enabled. (Refer
to
Release Notes for details.)
• Disabled -- FQDN cloud discovery off.
Set Controller
Address
• Enabled -- The AP uses an IP address to search for the primary
and/or secondary SCG, SZ, vSZ or ZD controller. When Set
Controller Address is Enabled, enter the required primary
controller IP address and the optional secondary controller IP
address.
• Disabled (default) -- The AP does not use IP address(es) to search
for SCG, SZ, vSZ or ZD controllers.
Table 56. Management Access Options (Continued)
Option Description
To Next Page
Loading...
