Managing the AP
Enabling Other Management Access Options
Ruckus Wireless Indoor AP 100.2.0 User Guide, 800-70892-001 Rev A 169
3 If you want to use TR-069 or SNMP to manage the AP, then configure the settings
listed in Tab l e 57 .
4 Click Update Settings to save your changes. A confirmation message appears
at the top of the page.
You have completed configuring the management access options.
PoE Operating
Mode (some APs)
AUTO = allow the AP to decide if it is to operate off of 802.3at or
802.3af power over Ethernet, or 802.3af PoE = force the AP to
operate off of 802.3af power over Ethernet. Default = AUTO.
Note: As described in ZoneFlex R710 AP section, the R710 AP
can operate off of 802.3af power, but the feature set is reduced.
Primary and
Controller Addr
Refer to Set Controller Address/Enabled above.
Table 57. TR-069 and SNMP Management Options
Option Description
Auto Enables the Ruckus Wireless device to be managed by
either SNMP server, Ruckus Wireless ZoneDirector, or
Ruckus Wireless FlexMaster.
SNMP only Only allow SNMP management.
FlexMaster only Only allow FlexMaster management.
DHCP Discovery URL of server providing DHCP.
FlexMaster Server URL URL of the FlexMaster server.
Digest-authentication
Username/Digest-
authentication password
This information is automatically generated by the AP and
used for authentication with FlexMaster. Change this value
only
if you want the AP to connect to another access
control server (ACS).
Periodic FlexMaster Inform
Interval
Interval at which the device should attempt to contact
FlexMaster. Default = 15 minutes.
Table 56. Management Access Options (Continued)
Option Description
To Next Page
Loading...
