Installing the AP
Step 1: Preconfiguring the AP
Ruckus Wireless Indoor AP 100.2.0 User Guide, 800-70892-001 Rev A 87
3 If you made any changes to the Common tab, click Update Settings.
4 Continue with “Configuring Wireless # (WLAN number) Settings” below.
Configuring Wireless # (WLAN number) Settings
1 Click one of the Wireless # (WLAN number) tabs.
Figure 40. The Configuration > Radio 5G > Wireless 9 tab
2 In Wireless Availability, click Enabled.
3 In Broadcast SSID, click Enabled.
Country Code • If you purchased the AP in the United States, this value is fixed to
United States at the factory and is not user configurable.
• If you purchased the AP outside the United States, verify that the
value is set to your country or region. Selecting the correct country
code ensures that the AP uses only the radio channels allowed in
your country or region.
Note for dual-band AP users: The two radios on dual-band APs are
always configured with the same country code setting. If you change
the country code for Radio 1, for example, the same change is
automatically applied to Radio 2.
Table 42. Common wireless configuration (Continued)
Setting Recommended Value
To Next Page
Loading...
