Web-based Configuration Guide System Settings
166
When it is enabled for the first time, SNMP v3 is enabled by default. Click OK.
(2) Set SNMP service global configuration parameters.
Table 5-1 Global Configuration Parameters
Indicates whether SNMP service is enabled.
Indicates the SNMP protocol version, including v1, v2c, and
v3 versions.
The port range is 1 to 65535.
1-64 characters. Chinese characters, full-width characters,
question marks, and spaces are not allowed.
1-64 characters. Chinese characters, full-width characters,
question marks, and spaces are not allowed.
(3) Click Save.
After the SNMP service is enabled, click Save to make basic configurations such as the
SNMP protocol version number take effect.
To Next Page
Loading...
