Web-based Configuration Guide System Settings
185
Table 5-8 Trap v1/v2c User Configuration Parameters
IP address of the trap peer device. An IPv4 or IPv6 address
is supported.
Trap version, including v1 and v2c.
The port range of the trap peer device is 1 to 65535.
Community name of the trap user.
At least 8 characters.
It must contain at least three character categories,
including uppercase and lowercase letters, digits, and
special characters.
Admin, public or private community names are not
allowed.
Question marks, spaces, and Chinese characters are not
allowed.
Caution
The destination host IP address of trap v1/ v1/v2c users cannot be the same.
Community names of trap v1/ v1/v2c users cannot be the same.
(3) Click OK.
3. Configuring Trap v3 Users
Overview
Trap v3 is a network management mechanism based on the SNMP protocol. It is used to
send alert notifications to administrators. Unlike previous versions, trap v3 provides
more secure and flexible configuration options, including authentication and encryption
features.
Trap v3 offers custom conditions and methods for sending alerts, as well as the
recipients and notification methods for receiving alerts. This enables administrators to
To Next Page
Loading...
Need help?
General
