ER-5200M/5240M Electronic Cash Register P-Mode Programming • 103
Program 150 - PLU Group Assignment
Each PLU may report to any three of 20 groups. Group totals appear on reports, so that you can track
sales of different types of items. A group can also be used to designate items that are to print on an
optional kitchen printer. The first of the three groups to which a PLU can be assigned determines
kitchen printer routing.
Note: The PLU will report to group "1", if not programmed to report to another group.
1. Turn the control lock to the P position.
2. To begin the program, enter 1 5 0, press the SBTL key.
3. Select the PLU or PLUs you wish to program in one of the following ways:
• Press a PLU key on the keyboard or scan the item.
• If sequential PLUs are to receive the same status, press the first PLU key and then
press the last PLU key.
• Enter the number of the PLU (up to 15 digits) and press the PLU key.
• Enter the number of the first PLU in a range of PLUs that are to receive the same
setting; press the PLU key. Enter the last number in the range; press the PLU key.
4. Enter up to three 2-digit numbers representing the groups where you wish to add the
PLUs sales, i.e. enter 1 0 for group 10 or enter 0 4 for group four. Press the X/TIME
key.
5. To program additional PLUs, repeat from step 3, or press the CASH key to finalize the
program.
1 5 0 SBTL
PLU
PLU PLU
PLU
PLU PLU
CASH
2
nd
Grou
1
st
Grou
3
r
Grou
X/TIME
To Next Page
Loading...
Need help?
General
