Sam4s ER-5200M - Memory Allocation Program

82 • S-Mode Programming ER-5200M/5240M Electronic Cash Register
Memory Calculation Example
The default memory allocation is shown below as a calculation example:
Variable Bytes per
unit
Default
Quantity
Total
PLU 78 1000 78,000
Clerks 1705 15 25,575
Groups 47 20 940
Guest Check 494 20 9,880
Lines per Soft Check 38 50 x 20
(guest check
quantity)
38,000
Mix & Match 20 25 500
Total Used 152,895
Total Available 187,144
Memory Allocation Program
Once you have determined the memory variable you wish to set, you can set them in the memory
allocation program. If you attempt to allocate more options than memory, the message “MEMORY
ALLOCATION SIZE OVER” will print on the receipt and journal.
1. Turn the control lock to the S position.
2. To Allocate Memory, enter 6 0 and press the SBTL key.
3. Refer to the chart below and enter a digit to represent allocated area and press the
X/TIME key.
4. Enter the desired allocation.
Note for the CHECK TYPE
entry: enter 0 for soft check
or enter 1 for hard check.
5. Repeat from step 3 to allocate another area, or press the CASH key to finalize the program.
If the allocation is accepted, the printer will print the new allocation. If the allocation is not
accepted, the message “ALLOCATION OVER . . .” will display.
X Allocated Area
1
PLU
2
CLERK
3
GROUP
4
CHECK#
5
SOFT CHECK LINES
6
CHECK TYPE : Hard(1), Soft(0)
7
MIX & MATCH
The total memory
used must be less that
the total memory
available
X X/TIME
CASH
0
SBTL 6
CASH