ER-5200M/5240M Electronic Cash Register P-Mode Programming • 161
Program 711 - Macro Name Programming
Up to ten function locations may be designated as Macro keys. You may wish to program a name for a
macro. For example if a macro executes a series of commands to produce daily reports, you can
program the descriptor “DAILY”, so the macro can easily be identified. Macro names can also be
helpful when looking at keyboard layout information with the PC communication utility.
1. Turn the control lock to the P position.
2. To begin the program, enter 7 1 1, press the SBTL key.
3. Enter the number of the Macro you wish to program (1-10); press the X/TIME key.
4. If you are programming using an alpha keyboard overlay, type up to 18 descriptors on
the overlay and press the SBTL key.
If you are programming using descriptor codes, enter up to 18 three-character codes and
press the X/TIME key. (See “Descriptor Code Chart” on page 99.)
5. Press the CASH key to finalize the program.
7 1 1 SBTL
Type up to 18
descriptor keys
SBTL
SBTL
Enter up to 18 three-
character codes
X/TIME
CASH
To Next Page
Loading...
Need help?
General
