118 • P-Mode Programming ER-5200M/5240M Electronic Cash Register
Print Option Programming
Refer to the “Print Option Table” to review the print options. Read each option carefully to determine
if you wish to make any changes.
NOTE: Because after clearing memory all options settings are automatically set to 0, and
because your most likely option selections require a status setting of 0, you do not need to
program this section unless you wish to change the default status.
Programming a Print Option
1. Turn the control lock to the P position.
2. Enter 4 0, press the SBTL key.
3. Enter a print option address and press the X/TIME key.
4. Enter the number representing the status you have selected, or if there is more than one
decision to be made in an address, add the values representing your choices for each
decision and enter the sum. Press the SBTL key.
5. Repeat from step 3 for each print option you wish to change.
6. Press the CASH key to end print option programming.
Print Option Flowchart
StatusOption #
SBTL X/TIME CASH
Repeat for each Print
Option
SBTL 0 4
To Next Page
Loading...
