Sam4s ER-5200M - Program 720 - Datatran Message Program

162 • P-Mode Programming ER-5200M/5240M Electronic Cash Register
Program 720 – DataTran Message Program
When a DataTran integrated payment appliance is connected, you can print a message of up to four
lines on the electronic payment draft receipt.
1. Turn the control lock to the P position.
2. To begin the program, enter 7 2 0, press the SBTL key.
3. Enter the number of the message line (1-4) you wish to program; press the X/TIME key.
4. If you are programming using an alpha keyboard overlay, type up to 32 descriptors on the
overlay and press the SBTL key.
If you are programming using descriptor codes, enter up to 32 three-character codes and press
the X/TIME key. (See “Descriptor Code Chart” on page 99.)
5. Press the CASH key to finalize the program.
7 2 0 SBTL
X/TIME
Type up to 32
descriptor keys
SBTL
SBTL
Enter up to 32 three-
character codes
CASH