Sam4s ER-5200M - Program 80 - Function Key Descriptor

ER-5200M/5240M Electronic Cash Register P-Mode Programming • 125
Program 80 - Function Key Descriptor
Program descriptors by typing descriptors on the alpha keyboard overlay or by entering three
digit alpha character codes. To enter descriptors by three digit alpha character codes you must
add a value of ‘1’ to system option #25 (See “System Option Programming” on page 112).
Note: You can program descriptors up to 18 characters, however only the first 10 will appear
on the display.
1. Turn the control lock to the P position.
2. To begin the program, enter 8 0, press the SBTL key.
3. If you are programming using an alpha keyboard overlay, type up to 18 descriptors on
the overlay and press the function key you are programming.
If you are programming using descriptor codes, enter up to 18 three-character codes and
press the function key you are programming key. (See “Descriptor Code Chart” on page
108.)
4. To program additional function keys, repeat from step 3, or press the CASH key to
finalize the program.
Descriptor Programs for the #/No Sale Key - Programs 80 & 81
Since two distinct functions, # entry and no sale, reside on the same key, different programs are used
to program each descriptor.
To program the no sale descriptor:
To program the # descriptor:
0 SBTL 8
Type up to 18
descriptor keys
FUNCTION
KEY
CASH
Repeat for another function ke
y
FUNCTION
KEY
CASH SBTL 0 8
Enter up to 18 descriptor codes, or
type 18 alpha overlay descriptors
Repeat for another function ke
y
FUNCTION
KEY
CASH SBTL 1 8
Enter up to 18 descriptor codes, or
type 18 alpha overlay descriptors
Enter up to 18 three-
character codes
FUNCTION
KEY