102 • P-Mode Programming ER-5200M/5240M Electronic Cash Register
Program 110 - PLU Auto Tare Programming
1. Turn the control lock to the P position.
2. To begin the program, enter 1 1 0, press the SBTL key.
3. Select the PLU or PLUs you wish to program in one of the following ways:
• Press a PLU key on the keyboard or scan the item.
• If sequential PLUs are to receive the same status, press the first PLU key and then
press the last PLU key.
• Enter the number of the PLU (up to 15 digits) and press the PLU key.
• Enter the number of the first PLU in a range of PLUs that are to receive the same
setting; press the PLU key. Enter the last number in the range; press the PLU key.
4. Enter a value (1-5) to indicate the number of the preprogrammed tare weight you want to
automatically subtract when the PLU is used for scale entry (using an optional scale), and
then press the X/TIME key. Enter 0 to disable automatic tare subtraction.
5. To program additional PLUs, repeat from step 3, or press the CASH key to finalize the
program.
1 1 0 SBTL
PLU
PLU PLU
PLU
PLU PLU
CASH
X/TIME
To Next Page
Loading...
Need help?
General
