Sam4s ER-5200M - Clerk Programming; Program 800 - Secret Code Programming

ER-5200M/5240M Electronic Cash Register P-Mode Programming • 151
Clerk Programming
Clerks (which may be used as cashiers), have the following programming options. These options are
set through separate programs:
• Program 800 - Secret Code programming determines the code that is used for clerk sign on
if a code entry sign on method is selected in system option #2 (See "System Option
Programming" on page 112.)
• Program 801 - If a second cash drawer is installed, Drawer Assignment determines which
cash drawer will be opened for each.
• Program 810 - Clerk Descriptor Programming allows you to set a unique, up to 18
character, descriptor for each clerk
Before attempting any programming, all clerks must first be signed off in REG mode.
Program 800 - Secret Code Programming
1. Turn the control lock to the P position.
2. To begin the program, enter 8 0 0, press the SBTL key.
3. Enter the number (1-99) of the clerk you wish to program; press the X/TIME key.
4. Enter a secret code (up to 6 digits); press the SBTL key.
5. Repeat from step 3 for each clerk you wish to program. Press the CASH key to finalize
the program.
8 0 0 SBTL
X/TIME
SBTL
Enter the secret
code, up to 6
digits
CASH