188 • Integrated Payment Appendix ER-5200M/5240M Electronic Cash Register
Reset Mode Procedures
DataTran Function Table
Function Procedure
Initialize EFT
Z-Mode: Enter 500, press SBTL
Open Batch
Z-Mode: Enter 501, press SBTL
Close Batch
Z-Mode: Enter 502, press SBTL
Clear Current Batch
Z-Mode: Enter 503, press SBTL
Change Batch Number
Z-Mode: Enter 504, press SBTL
Issue Local Total
Z-Mode: Enter 505, press SBTL
Issue Transaction
Z-Mode: Enter 506, press SBTL
Issue Batch Status
Z-Mode: Enter 507, press SBTL
Dial In Load
Z-Mode: Enter 508, press SBTL
Dial Out Load
Z-Mode: Enter 509, press SBTL
Tip Entry
Z-Mode: Enter 510, press SBTL
Pin Pad Initialize
Z-Mode: Enter 511, press SBTL
Close Batch with Debit
Z-Mode: Enter 512, press SBTL
Initialize EFT
Z-Mode: Enter 500, press SBTL
Select Initialize EFT to verify communications, software versions and installed networks.
DATE 5/24/2004 THU TIME 16:15
** LIST INSTALLED NETWORKS **
VS2 CHK GFT --- VER:4.00
ON ON ON OFF
CLERK1 000066 00000
Clear Curr Batch
Z-Mode: Enter 503, press SBTL
The clear batch command erases all the current batch transactions from the DataTran memory even if
they have not been settled. A LOCAL TRANSACTION INQUIRY should be printed prior to clearing
the batch. This will ensure that the operator has the transaction detail to re-enter if required.
This operation should only be done under the direction of DATACAP.
List of Installed Networks
Status of Installed
Software Version
To Next Page
Loading...
