Sartorius Cubis MCE Series User Manual

18 Cubis
®
MCE Operating Instructions
Operating Concept
Level 1 Level 2 Level 3 Description
DEVICE RS-232
“COM-RS232, 9-pin”
DAT.REC. Set the communication protocol for the connected device.
BAUD Set the baud rate for the connected device.
PARITY Set the parity for the connected device.
STOPBIT Set the number of stop bits.
HANDSHK. Set the handshake between the balance and the device.
DATABIT Set the number of data bits.
PC-USB
“USB-B
(Device/Slave)”
DAT.REC. Set the communication protocol for the connected PC.
BAUD Set the baud rate for the connected PC.
PARITY Set the parity for the connected PC.
STOPBIT Set the number of stop bits.
HANDSHK. Set the handshake between the device and the connected
PC.
DATABIT Set the number of data bits.
USB
“USB-A (Host/Master)”
DEV.USED
“Device in use”
Display the device connected via USB-A.
LEVELING
“Leveling”
LEVEL Define the settings for the integrated inclination sensor.
START Define the trigger for automatic leveling.
MOTION.S.
“Motion sensor”
CONTROL Activate / deactivate the motion sensor.
NUM.GEST.
“Number”
Define the number of possible gestures.
LEFT CMD. Define the function for the left gesture.
RIGHT.CMD. Define the function for the right gesture.
UP.CMD. Define the function for the up gesture.
DOWN.CMD. Define the function for the down gesture.
EXTRAS MENU Lock or unlock the menu’s configuration parameters.
SIGNAL Set or deactivate the acoustic signal.
KEYS Activate / deactivate the key lock.
ON MODE
“Switch-on and
switch-off options”
Configure the device’s switch-on and switch-off options,
e.g. switch between standby mode and operating mode.
LIGHTING Activate / deactivate the lighting for the operating display.
DATA.OUTP.
“Data output”
COM. SBI
“SBI communication”
COM.OUTP. Configure the automatic data output.
STOP.AUTO Define whether the automatic data output can be stopped
and started with the [Print] key.
AUTO.CYCL.
“Time-dependent
interval”
− Define an interval for the automatic data output.
− Define whether data output takes place after an
interval with or without balance stability.
FORMAT Define the data output format (characters per line).
AUTO.TARE Activate / deactivate automatic taring after the printout.

Sartorius Cubis MCE Series Specifications

General

Brand	Sartorius
Model	Cubis MCE Series
Category	Scales
Language	English