Sartorius Entris II BCA Advanced Series - Page 30

30 Entris
®
II Advanced Line Operating Instructions
Operating Concept
Parameters Settings Explanation
Automatic
tare
On Activates automatic taring after the components are saved.
Off* Deactivates automatic taring after the components are saved.
* Factory setting
Parameters of the “Density” Application
Parameters Settings Explanation
Density of
liquid
Defines the density of the buoyancy liquid, e.g., distilled water:
 0.9982 g/cm
3
at 20°C
 0.9980 g/cm
3
at 21°C
 0.9978 g/cm
3
at 22°C
Accuracy 0-0,000 Defines the number of decimal places.
* Factory setting
Parameters of the “Percent” Application
Parameters Settings Explanation
Reference Defines the reference percentage.
Accuracy 0-0,000 Defines the number of decimal places.
* Factory setting
Parameters of the “Conversion” Application
Parameters Settings Explanation
Factor Defines a factor by which the weight value is multiplied.
Accuracy 0-0,000 Defines the number of decimal places.
* Factory setting
Parameters of the “Animal Weighing” Application
Parameters Settings Explanation
Measurements Defines the number of measurements.
* Factory setting