30 Programming SATEL
3.2.2 Modem communication parameters
Programming the parameters
Telephone numbers
You can program the telephone numbers:
• keypad: functions available in the SM SETTINGS submenu (SERVICE MODE SM SETTINGS).
• DLOADX program: “Connection settings” window (the command for opening this window is
available in the “Communication” menu; you can also use the Ctrl+R key combination).
Control panel settings
You can configure the modem communication settings when programming the telephone
options (see: “Telephone options” p. 68).
DLOADX program settings
You can configure the modem communication settings in the “Configuration” window,
“Modem” tab.
Description of parameters
Telephone numbers
Panel’s tel. no – telephone number of the control panel.
PC phone number – telephone number of the modem connected to computer with DLOADX
program installed.
Control panel settings
Parameters and options related to modem communication are described in section
“Telephone options” (p. 68).
DLOADX program settings
You can define three sets of parameters for the modem connected to computer:
• analog modem for communication with the built-in modem of the control panel,
• analog modem for communication with the external modem of the control panel,
• ISDN or GSM modem for communication with the ISDN or GSM modem of the control
panel.
After clicking on the button you can configure the selected set of parameters (see:
“Configuring the modem connected to computer”).
Dialing – the method of dialing numbers by the modem connected to computer (tone or
pulse).
Dial tones control – if option is enabled, the modem connected to computer will detect the
dial tone or busy signal before dialing the number.
Speaker – operating mode of the modem speaker. The speaker can be always OFF, or ON
until connection with the control panel is established (auto), or always ON.
Volume – volume of modem speaker.
Answering – how the DLOADX program reacts when the control panel is connecting to the
program. Communication can be established automatically after a preset number of rings,
or the program will only indicate an attempt to establish communication by the control
panel (communication will only be established after clicking on the “Answer” button).
Double call – you can define duration of the pause between the first and the second call, if
the control panel is set to go off-hook after the second call.
To Next Page
Loading...
