Satel INTEGRA Plus - 14 Manual Update History

SATEL INTEGRA Plus 97
14. Manual update history
Date
Firmware
version
Introduced changes
2013-08 1.12
• Information on INTEGRA 256 Plus control panel has been added.
• Section “Hiding the service mode” has been added (p. 6).
• List of functions available in the service mode menu has been supplemented
(p. 6-25).
• Note has been added to inform in which situations the local programming
function must be disabled (p. 34).
• Description of how to configure the GSM module for GPRS remote
programming has been modified (p. 42).
• Description of 3. I
NTERIOR DELAYED type zone has been modified (p. 52).
• Description of 93. O
UTPUTS GROUP ON type zone has been added (p. 54).
• Description of D
ELAY IN 2&3 TYPE ARMING option has been added (p. 55).
• Description of 95. IP
REPORTING TROUBLE type output has been modified
(p. 63).
• Description of 118. K
EYFOB BATTERY LOW type output has been modified
(p. 64).
• Description of 119. W
IRELESS MODULE JAMMING type output has been modified
(p. 64).
• Note on the forcing output has been added (p. 66).
• Note on displaying the output status and zone 256 has been added (p. 59).
• Description of R
EPORTING – ETHM-1 option has been modified (p. 68).
• Description of R
ETURN TO MENU FROM MENU “TEST” has been modified (p. 70).
• Description of G
RADE 3 option has been modified (p. 72).
• Description of T
AMPER IF NO COMMUNICATION WITH ABAX DEVICE (2H) option
has been added (p. 73).
• Description of H
IDE SERVICE MODE AFTER option has been modified (p. 74).
• Description of D
O NOT REPORT TIME SERVER TROUBLE option has been added
(p. 74).
• Note about INTEGRA 256 Plus control panel and CHIME signal in keypads
has been added (p. 77).
• Note about chime disabling zone has been added (p. 77).
• Note about controlling authentication method and outputs 255 and 256 has
been added (p. 82).
• Note about INTEGRA 256 Plus control panel and auto-backlight has been
added (p. 79
).
• Description of timer exceptions has been modified (p. 82).
• Description of IP
FORMAT parameter has been added (p. 86).
• Description of P
ROTOCOL parameter has been added (p. 86).
• Section describing additional parameters for SIA-IP reporting has been
added (p. 87).
• Section on reporting via Ethernet has been modified (p. 89).
• Section on GPRS reporting stating has been modified (p. 89).
• Information on ACU-250 and INT-RX-S modules has been added.
2013-12 1.12
• Information on the INT-KLFR , INT-TSG and INT-TSI keypads has been
added.
• Information on INT-RS Plus module has been added.
2014-10 1.13
• Information on ACU-120 and ACU-270 controllers has been added.
• Information on ETHM-1 Plus module has been added.
• List of functions available in the service mode menu has been supplemented
(p. 6-25).