Satel INTEGRA Plus - 12 Answering Phone Calls and Remote Control; Telephone Answering and Control Parameters and Options

SATEL INTEGRA Plus 95
5. Record or synthesize the voice messages which are to be used for messaging (see:
CA-64 SM synthesizer or INT-VG voice module manual).
6. For events about which the control panel is to inform, indicate:
– number of the voice message to be used for messaging,
– telephones to be notified.
7. In order to limit unnecessary messaging, define the cases in which notification can be
cancelled (the parameters CLEARING IN PARTITIONS and CLEARING AFTER ACKNOWLEDGEMENT
and the option CLEAR MESSAGING ON ALARM CLEARING).
12. Answering phone calls and remote control
The call answering function allows the control panel users to receive information on
the partition status (arm mode, alarms). Owing to the telephone control function, the users
can control the REMOTE SWITCH outputs by means of a telephone.
The INT-VG module offers a much larger scope of the alarm system remote operation
functionality using a telephone.
The parameters of telephone answering and control can be programmed:
• using the keypad, in the service mode, by means of the functions available in the
TEL.ANSW./CTRL. submenu,
• using the DLOADX program, in the “Answering and remote control” window.
12.1 Telephone answering and control parameters and options
See also section “Telephone options” p. 68.
Fig. 13. “Answering and remote control” window in the DLOADX program.
Shown in square brackets are the names used in keypads.
Answer if all chosen partitions are armed [On armed part.] – you can indicate the
partitions whose status will affect the telephone answering and control functions (they will
only be executed, if all indicated partitions are armed).
If the ANSWERING - MODEM option is enabled, the control panel will be answering
the calls whether the partitions are armed or not.