Satel INTEGRA Plus - Operation Under Duress; Operating the System via LCD Keypad; 5.1 Keypads Description; 5.1.1 LCD display

SATEL INTEGRA Plus 5
1. General
This manual applies to the control panels of the INTEGRA Plus series:
– INTEGRA 64 Plus
– INTEGRA 128 Plus
– INTEGRA 256 Plus
The control panel may be programmed:
• locally
– LCD keypad,
– computer with the DLOADX program installed, connected to the control panel RS-232
or USB port,
• remotely
– computer with the DLOADX program installed, communicating via the telephone
network (through modem or GPRS) or via the Ethernet network. Modem communication
can take place via the built-in control panel modem or an external modem connected to
the control panel. For GPRS communication to be possible, the INT-GSM module must
be installed in the alarm system or the SATEL GSM module must be connected to the
control panel. Communication over Ethernet is possible after connecting the ETHM-1
Plus / ETHM-1 Ethernet module to the control panel.
– virtual keypad available in the internet browser, mobile phone or smartphone.
Programming the control panel is possible when:
– the PERMANENT SERVICE ACCESS option is enabled (the option is enabled by default – the
control panel can be programmed by any method),
– the PERMANENT DLOADX ACCESS option is enabled (the option is enabled by default –
the control panel can only be programmed by means of the DLOADX program),
– the installer has been granted a temporary access to the control panel using the
SERVICE ACCESS function (the control panel can be programmed by any method).
The standards require that the administrators (masters) limit the installer access after
installation is finished.
2. Configuring the control panel with keypad
Programming the control panel with keypad (real or virtual) should be carried out using the
service functions, available in the service mode menu. Some features may not be available in
the virtual keypads.
2.1 Starting the service mode
1. Enter the service code (by default 12345) and press the key.
2. Using the  or  key, select the item SERVICE MODE from the list and press the or 
key.
You can also start the service mode using the key shortcut:
[service code] 9
The service mode is indicated in the keypads by lighting of the LED. It can also be
signaled by beeps if the appropriate option is enabled.
In the service mode, only alarms from the 24H VIBRATION, 24H CASH MACHINE, PANIC-
AUDIBLE and PANIC-SILENT type zones are possible.