Satel INTEGRA Plus - Keypad

SATEL INTEGRA Plus 77
This section covers the INT-KLCD, INT-KLCDR, INT-KLCDK, INT-KLCDL,
INT-KLCDS and INT-KLFR keypads. Parameters and options for other keypads are
described in their respective dedicated manuals.
Shown in the square brackets are the names, as used in the keypads.
7.1.1 Keypad
Name – individual name of the LCD keypad (up to 16 characters).
Partitions managed by keypad [Partitions] – partitions which can be armed/disarmed or
alarm in which may be cancelled from the keypad. These functions are available to the
users having appropriate rights and access to these partitions.
Using the service code you can operate all partitions, irrespective of which partitions
are operated by the keypad.
Show alarms of partitions [Alarms] – the keypad can signal burglary alarms from selected
partitions.
Show fire alarms of partitions [Fire alarms] – the keypad can signal fire alarms from
selected partitions.
CHIME signal of zones [Chime zones] – the keypad can audibly signal violation of selected
zones. If the zone is armed, violation will not trigger the CHIME signal.
In the case of the INTEGRA 256 Plus control panel, violation of zone numbers 129 to
256 will be indicated by the INT-KLFR / INT-TSG / INT-TSI keypads and the keypads
with firmware version:
− INT-KLCD / INT-KLCDR – 1.12 (or newer),
− INT-KLCDK / INT-KLCDL / INT-KLCDS – 6.12 (or newer),
− INT-KSG – 2.00 (or newer).
Zone disabling CHIME [Chime bps. zone] – zone, which, if violated, will disable the CHIME
feature for specified time.
The zone 256 cannot disable the CHIME feature.
Bypass time [Chime bps. time] – time during which the CHIME signal will be disabled after
violation of the zone which disables the signaling (time is counted from the zone restore). If
the value 0 is programmed, the signaling will not be disabled.
Quick Arm partitions [Quickarm part.] – partitions which will be armed in case of the quick
arming (see: USER MANUAL).
Display entry delay of partitions [Show entry del.] – information on entry delay countdown
in selected partitions can be displayed on the keypad.
Display exit delay of partitions [Show exit delay] – information on exit delay countdown in
selected partitions can be displayed on the keypad.
Signal entry delay of partitions [Sign.entry del.] – the entry delay countdown in selected
partitions can be audibly signaled on the keypad.
Signal exit delay of partitions [Sign.exit delay] – the exit delay countdown in selected
partitions can be audibly signaled on the keypad.
Date/Time format – the format in which the date and time are to be displayed on the keypad.
LCD backlight – selection of the display backlighting type.
Keys backlight – selection of the keypad backlighting type.
Alarm messages
Partitions [Part.al.msg.] – if this option is enabled, messages on partition alarms will be
displayed (they contain the name of partition).