78 Programming SATEL
Zones [Zone al.msg.] – if this option is enabled, messages on alarms from zones will be
displayed (they contain the name of zone). The zone alarm messages have the priority.
Alarms
FIRE [Fire alarm] – if this option is enabled, pressing the key for approx. 3 seconds will
trigger the fire alarm.
PANIC [Panic alarm] – if this option is enabled, pressing the key for approx. 3 seconds
will trigger the panic alarm.
AUX. [Medical alarm] – if this option is enabled, pressing the key for approx. 3 seconds
will trigger the medical alarm.
3 wrong codes [3 wrong codes] – if this option is enabled, entering incorrect code three
times will trigger the alarm.
Additional options
Silent PANIC alarm [Silent panic] – if this option is enabled, the panic alarm triggered from
the keypad will be a silent one, i.e. the keypad will not indicate it, there will be no audible
signal, but the alarm will be reported to the monitoring station. The silent panic alarm is
useful when the control panel is sending events to the monitoring station, but unauthorized
persons should not be aware of the alarm being triggered.
Sign. alarms [Alarm signal.] – with this option enabled, the keypad will signal the alarms
audibly.
Key sounds [Key sounds] – with this option enabled, pressing the keypad keys is confirmed
by beeps.
Sign. trbl. in part. arm [Trbl.in p.arm.] – if this option is enabled, the LED goes off after
all managed by keypad partitions are armed (if the option is disabled, the LED goes off
after just one of the partitions is armed).
Sign. new trouble [New trbl.sign.] – with this option enabled, the keypad can audibly signal
the occurrence of a new trouble (if the TROUBLE MEMORY UNTIL REVIEW option is enabled).
New trouble signaling is cleared after the troubles have been reviewed by the user.
Show code entering [Show code ent.] – with this option enabled, entering the code is
presented on the keypad display by asterisks.
Show keypad name [Name (2nd row)] – with this option enabled, the keypad name is
presented in the lower line of the display.
Exit delay clearing enable [Fin.exit delay] – with this option enabled, the exit delay time in
partitions with the EXIT DELAY CLEARING option enabled can be shortened after pressing in
turn the 9
keys.
Show viol. zones [Zone violation] – with this option enabled, violating the CHIME signal
triggering zone result additionally in the zone name being displayed.
Auto-Arm delay countdown [Auto-arm delay] – with this option enabled, the auto-arm delay
countdown in partition is signaled acoustically.
Displ. mode switching [Dspl.mode chg.] – with the option enabled, you can toggle the
display between the standby mode and the partition status display mode by using the 9
key.
Show disarm messages [Show disarming] – if this option is enabled, the keypad will inform
about disarming with a displayed message at all times. If the option is disabled – only in
case of disarming from the given keypad.
Show arm messages [Show arm] – if this option is enabled, the keypad will inform about
arming with a displayed message (irrespective of how the system was armed).
To Next Page
Loading...
