SATEL INTEGRA Plus 93
Code – 4 digits which, when entered from the telephone keypad, will acknowledge reception
of the voice message.
If no code has been programmed to acknowledge receipt of the voice message, nor
the ANY CODE option has been enabled, the control panel will recognize receipt of the
message as acknowledged when the receiver is picked up after two rings and any
sound occurs.
User – if a code has been programmed to acknowledge receipt of the voice message or the
ANY CODE option has been enabled, a user can be assigned to the telephone. Thus, if the
INT-VG module is connected to the control panel, the user will be automatically granted
access to the voice menu after acknowledgement of the voice messaging.
11.1.2 Events assignment
Enter the following information for the events of which the control panel is to notify:
• number of the voice or text message by means of which messaging will be effected,
• telephones which will be notified.
11.1.3 Clearing
In partitions [Msg.abort in P.]
For each telephone, you can indicate partitions in which clearing an alarm will cancel
messaging that alarm (messaging to that telephone number will be canceled, but can be
continued to other numbers).
After acknowledgement [Msg.abort on T.]
You can indicate telephones which will not be notified about the event, if the control panel
receives acknowledgement that the voice message has been received by another, indicated
telephone.
11.1.4 Pager messages
Define the content of messages which will be used for PAGER type messaging.
11.1.5 Pager type
For messaging using the PAGER type messages, you must define the parameters of pager
identification. Default parameters of the pager type 1 are adjusted to the SATEL GSM
module requirements for conversion of the PAGER type message into SMS message.
11.2 SMS messaging parameters and options
The settings described below apply to SMS messaging via the SATEL GSM module. The
settings are not available, when the INT-GSM module is installed in the alarm system. The
settings for SMS messaging via the INT-GSM module are described in the INT-GSM module
manual.
Name – individual telephone name (up to 16 characters).
ON – if this option is enabled, messaging to the given telephone will be possible.
Telephone no. – telephone number which will be notified.
11.2.1 Events assignment
Select the types of events which, if occur in the selected partitions, will result in SMS
messaging.
11.3 E-mail messaging parameters and options
Email address – e-mail address to which event notifications will be sent.
To Next Page
Loading...
