Satel INTEGRA Plus - Keyfob Operation and Audio Verification; 10.3 Audio alarm verification; 11. Operating the alarm system by means of keyfob

SATEL INTEGRA Plus 43
Initiating a connection
1. Click on the button in the DLOADX program.
2. A drop-down menu will be displayed. Select “TCP/IP: DLOADX <- GSM/GPRS”.
3. A window will open. Enter the following information in the corresponding fields:
– number of the TCP port which is to be used for communication (identical to that
programmed in the GSM module, unless communication takes place via a network
device redirecting to another port),
– data encryption key (identical to that programmed in the GSM module).
4. Having entered the number of TCP port and data encryption key, click the “Start” button.
Activation of the server for GPRS connection will follow.
5. Send to the GSM module the following SMS message:
zzzzzz. or zzzzzz= (“zzzzzz” – the control command programmed in the GSM module
initializing GPRS communication with the DLOADX program) – the GSM module will
connect the control panel to the computer whose address is programmed in the
module,
zzzzzz=aaaa:p. or zzzzzz=aaaa:p= (“zzzzzz” – the control command programmed in the
GSM module initializing GPRS communication with the DLOADX program; “aaaa” –
address of the computer with DLOADX program (IP address or domain name); “p” –
TCP port) – the GSM module will connect the control panel to the computer whose
address is given in the SMS message (the computer address programmed in the GSM
module will be ignored).
6. The DLOADX program will inform you about establishing connection by means of
a suitable message.
3.5 Control panel data file
After readout of the control panel data, you can save the data file to the computer disk. The
data file is encrypted. Default encryption prevents the data file from being opened in other
location than the disk where the DLOADX program, which was used to save the data, is
installed. You can change the default key for data encryption (“File” “Access setup” “Data
files encryption key”). If you use an encryption key other than the default one, you can open
the control panel data file in any location, after entering the encryption key.
You can export the control panel data file (“File” “Export/Import” “Export file”). Once the
file is exported, it can then be imported from any computer (“File” “Export/Import” “Import
file”). When exporting the file, you can enter the encryption key which will be required during
import of the file.
All the data files can be exported (“File” “Export/Import” “Export all”). In this case, you will
be required to enter the encryption key.
4. System structure
The system can be subdivided into objects (subsystems). Partitions are assigned to each
object and zones are assigned to partitions.