Satel INTEGRA Plus - Page 55

SATEL INTEGRA Plus 53
34. 24H FIRE – COMBUSTION
35. 24H FIRE – WATER FLOW (FIRE)
36. 24H FIRE – HEAT
37. 24H FIRE – PULL STATION
38. 24H FIRE – DUCT
39. 24H FIRE – FLAME
The zone types from 32 to 39 cause a fire alarm. The names of zones and codes of events
from these zones are consistent with the Contact ID reporting format. The fire zones (except
for 24H FIRE – BUTTON) can work with alarm verification.
40. 24H FIRE SUPERVISORY
41. 24H LOW WATER PRESSURE
42. 24H LOW CO2
43. 24H WATER VALVE DETECTOR
44. 24H LOW WATER LEVEL
45. 24H PUMP ACTIVATED
46. 24H PUMP FAILURE
47. NO ALARM ACTION – may be used to control the outputs. Additional options (STORE TO
EVENT LOG
, NO REPORTING and STORE EVENT ONLY IF ARMED) enable the zone to be used for
other applications e.g. supervising the keybox.
48. 24H AUXILIARY – PROTECTION LOOP
49. 24H AUXILIARY – GAS DETECTOR
50. 24H AUXILIARY – REFRIGERATION
51. 24H AUXILIARY – LOSS OF HEAT
52. 24H AUXILIARY – WATER LEAKAGE
53. 24H AUXILIARY – FOIL BREAK
54. 24H AUXILIARY – LOW BOTTLED GAS LEVEL
55. 24H AUXILIARY – HIGH TEMPERATURE
56. 24H AUXILIARY – LOW TEMPERATURE
57. TECHNICAL – DOOR OPEN – zone intended for supervising the status of the door defined as
DEPENDENT DOOR in the module executing the access control functions (partition keypad,
code lock, readers expander).
58. TECHNICAL – DOOR BUTTON – zone violation will result in opening the door controlled by
the module executing the access control functions (partition keypad, code lock, readers
expander).
59. TECHNICAL – AC LOSS – intended for control of devices working together with the alarm
control panel e.g. additional power supply units. Violation of the zone will cause a trouble
condition.
60. TECHNICAL – BATTERY LOW – intended for control of the batteries of additional power
supply units working in conjunction with the control panel. Violation of the zone will cause
a trouble condition.
61. TECHNICAL – GSM LINK TROUBLE – intended for control of the external GSM
communication module. Violation of the zone will cause a trouble condition.
62. TECHNICAL – OVERLOAD – intended for control of an additional power supply unit used
together with the control unit. Violation of the zone will cause a trouble condition.
63. TROUBLE – violation of the zone will cause a trouble condition.
64...79 BYPASSING – GROUP: 1–16 – violation of this type of zone can bypass a group
of zones (see: “Bypasses” p. 57).