SATO CG4 Series - Page 63

Section 4: Operation and Configuration
CG4 Series Service Manual Page 4-25
4.13 FACTORY ADJUSTMENT MODE (cont’d)
Notes:
• Restart the printer by pressing the POWER off and then on, the setting is then saved.
• If you missed the chance to release the
FEED/LINE button in step 2 above, just keep holding the
FEED/LINE button and wait for the next cycle.
• If you released the
FEED/LINE button at the wrong ON LINE (POWER) indicator, just turn off the power
and restart the procedure.
• If an error occurred during adjustment, open the top cover once. Then press the
FEED/LINE button after
closing the top cover to restart the adjustment.
• The printer will continuously print the Factory test labels until the
FEED/LINE button is pressed. The
printing is paused and will resume printing if the
FEED/LINE button is press again.
Printer statusProcedures
ON LINE (POWER)
indicator
ERROR
indicator
Buzzer
Press the FEED/LINE
button to execute the
Gap sensor output
adjustment.
Blinking green light
Press FEED/LINE button
to start test printing.
Green light
Factory Test Print start
and print continuously.
Press FEED/LINE button
to pause the test printing.
Press again to resume.
Factory Test Print
paused.
Blinking green light
5
6
Off
Off
Off
Off
The printer will feed at
least 3 labels to adjust
the Gap sensor auto-
matically.
The printer is paused
and is ready for the
Factory Test printing.
Green light