SATO CG4 Series - Page 65

Section 4: Operation and Configuration
CG4 Series Service Manual Page 4-27
4.13 FACTORY ADJUSTMENT MODE (CONT’D)
Third print-out
No. Print Item Contents of the print data
1 Model Printer model name
CG408TT(*), CG412TT(*)
CG408DT, CG412DT
*: “T” is printed for thermal
transfer print.
“D” is printed for direct
thermal print.
2 CONT/USB Serial USB serial No. ********
3 Life Counter Life counter *.* Km
4 Head Counter1 Head counter1 *.* Km
5 Head Counter2 Head counter2 *.* Km
6 Head Counter3 Head counter3 *.* Km
7Cutter Counter
Cutter counter
********
8 Offset Pitch offset value
(Vertical/ Horizontal direc-
tions)
(H)±***
(V)±***
9 Cut Offset Cut position offset value ±*** DOT
10 Peel Offset Peel off position offset value ±*** DOT
11 TearOff Offset Tear off position offset value ±*** DOT
12 Label Size Label size (Pitch/Width) (P)**** x (W)*** DOT
13 Thermistor Print head temperature ***
14 Print Mode Operation mode CONTINUOUS
TEAR OFF
CUT
DISPENSER
NON SEPA
15 Sensor Type Sensor type
(I-Mark/ Gap)
I-Mark
Gap
None
16 Sensor Level Low Average minimum value of
pitch sensor
*.* V
17 Sensor Level High Average maximum value of
pitch sensor
*.* V
18 Sensor Slice Level Pitch sensor slice level *.* V
19 Print Speed Print speed 50mm/s
75mm/s
100mm/s
20 Print Darkness Print darkness 1A~5A