SATO CG4 Series - Page 83

Section 5: Troubleshooting
CG4 Series Service Manual Page 5-13
5.2 TROUBLESHOOTING FLOWCHART (cont’d)
5.2.8 Linerless (Non Sepa) Problem (Optional)
Category
Symptoms
Causes Remedy
Maintenance
Refer to 4.16
Printer Configura-
tions Setting
NO
YES
NO
YES
Is
Linerless platen
roller clean?
Labels
are not
dispensed
NO
YES
NO
YES
Is
Linerless
(Non sepa) label
sensor working
OK?
Linerless
(Non sepa)
(optional)
Replace
Main PCB
Refer to 7.5 Main
Circuit Board
Replacement
Replace
Linerless (Non
sepa) Label
Sensor
Set to Linerless
(Non sepa)
Mode
Clean the
Linerless platen
roller
Is printing
mode correctly
set?
Labels feed
continously
Is Linerless
(Non sepa)
unit correctly
set?
Refer to 7.15
Linerless (Non
sepa) Label Sensor
Replacement
Refer to 7.2
Platen Roller
Replacement for
the similar
procedure in
replacing the
Linerless platen
roller.
Replace
Linerless platen
roller
Set Linerless
(Non sepa)
unit correctly