SATO CG4 Series - Page 82

Section 5: Troubleshooting
Page 5-12
CG4 Series Service Manual
5.2 TROUBLESHOOTING FLOWCHART (cont’d)
5.2.7 Label Dispenser Problem (optional)
Category
Symptoms
Causes Remedy
Maintenance
Refer to 4.16
Printer Configura-
tions Setting
NO
YES
NO
YES
Set dispenser
unit correctly
Is Dispensing
roller clean?
Labels
are not
dispensed
NO
YES
NO
YES
Is dispenser
label sensor
working OK?
Label
dispenser
(optional)
Replace
Main PCB
Refer to 7.5 Main
Circuit Board
Replacement
Replace
Dispenser Label
Sensor
Set to Dispenser
Mode
Clean the
Dispensing roller
and Platen roller
Is printing
mode correctly
set?
Labels feed
continously
Is Dispenser
unit correctly
set?
Refer to 7.14
Dispenser
Label Sensor
Replacement
Refer to 7.14
Dispenser Roller
Replacement &
7.2 Platen Roller
Replacement
Replace
Dispensing roller
and Platen roller