95
www.sauservice.com
● Remove the 8 screws and replace
the solenoid.
● Remove the 2P connector, wire and
4 screws to take off the solenoid
assembly.
SOLENOID ASSEMBLY
Remove the connector.
WIRE
SCREW (4)
M3×6, w/spring washer
PHOTO 10 g
SCREW (8) l
M3×6, w/spring washer
SOLENOID
PHOTO 10 h
● Secure the solenoid assembly with 4 screws and replace the connector. When doing this, make sure not to
damage the wiring.
● Refer to the previous item, then attach COVER R while being careful of each of the parts.
● After replacement, perform an OUTPUT TEST, referring to the instructions in "Game Test Mode".
To Next Page
Loading...
