43
www.sauservice.com
7.
PRECAUTIONS WHEN MOVING THE MACHINE
● Do not move the product with a GD-ROM disc inside. Remove the
GD-ROM disc before moving the product.
Failure to observe this instruction may cause the GD-ROM disc and/or GD-ROM
drive to be damaged.
● Do not hold or press the plastic parts as indicated by the Figure 7c. Failure to ob-
serve this instruction may break the parts, and eventually the broken pieces may
cause a personal injury.
● When moving the machine, be sure to remove the foot pedals. Moving with the foot
pedals may cause an accident, and deform or damage the part/floor.
● When moving the machine, be sure to pull out the plug from the power supply. Mov-
ing the machine with the plug as is inserted can cause the power cord to be damaged
and could result in a fire and or electric shock.
● When moving the machine on the floor, retract the Adjusters and ensure that Casters
make contact with the floor. During transportation, pay careful attention so that Cast
-
ers do not tread power cords and earth wires. Damaging the power cords can cause
an electric shock and or short circuit.
● In places where step-like grade differences exist, be sure to separate the PTV, PTV
Cabinet, and the Controller Cabinet. Inclining the PTV as is mounted on the PTV
Cabinet can cause the PTV to fall off from the Base and result in injury.
● When lifting the cabinet, be sure to hold the grip portions or bottom part. Lifting the
cabinet by holding other portions can damage parts and installation portions due to
the empty weight of the cabinet, and cause personal injury.
● When moving the PTV, do not push it from the rear side. Push it from sideways.
Pushing the PTV from the rear side can have the PTV fall down, causing personal
injury etc. In case the floor has slanted surfaces or step-like differences, be sure to
move the machine by 2 or more persons.
● When the Cabinet is disassembled, the detached Controller Cabinet may be unstable.
If it is carelessly pushed, it can fall and cause accidents. When the Control Cabinet
is detached, place it in on a level surface and be careful not to tip it right or left when
moving it.
CAUTION!
WARNING!
To Next Page
Loading...
