89
www.sauservice.com
In cases where the gun's operation is unsatisfactory or the gun sight deviates from the direction in
which the control unit is pointed, the gun's interior parts may have been damaged. Replace the parts by
disassembling the gun with the procedure described below. Also, be sure to perform a sighting check in
the test mode when the gun parts are replaced.
● Do not cut the tie belt securing the wires in the Control Unit (Gun Controller).
Cutting the tie belt may cause malfunctioning of the wire connection. If you cut the
tie belt when replacing the wire etc., be sure to secure the wires using a new tie belt
as before.
● Follow these directions carefully to avoid damaging or losing small parts.
10. CONTROL UNIT (GUN CONTROLLER)
● When securing the plastic-made parts, do not excessively fasten screws and nuts.
Failure to do this may damage the parts, and fragments resulting from damage may
cause injury.
● When reassembling the Gun Controller, be sure to check the connecting portion and
the trigger, etc. If the reassembly work is insufficient and/or incorrect, fingers may
be caught and result in injury.
● The solenoid on the Control Unit (Gun Controller) may become hot. Take care as
there is a risk of accidental burns.
● In order to prevent any electric shocks or short circuits, be sure to turn the power off
before performing any work that involves touching the interior parts of the product.
● Be careful not to damage the wires. Damaged wires may cause electric shocks or
short circuits, or present a risk of fire.
● Be very careful when soldering. Handling a soldering iron carelessly may result in a
fire or a burn.
CAUTION!
STOP
IMPORTANT!
WARNING!
To Next Page
Loading...
