103
www.sauservice.com
12. PROJECTOR
FIG. 12. 1
Since the Projector has been adjusted at the time of shipment, avoid making further
adjustments without good reason.
The Projector is subject to color deviation due to Convergence deviation caused by
the geomagnetism at the installation location and peripheral magnetic field. After the
installation of machine, and before commencing operation, check for Convergence
deviation and if deviated, make adjustments.
When the screen surface becomes dirty
with dust, etc., clean it by using a soft cloth
such as gauze. When water, and volatile
chemicals such as benzine, thinner, etc., spill
on the screen surface, it may be subject to
damage, therefore, do not use them. Also,
since the surfaces are susceptible to damage,
refrain from rubbing them with a hard
material or using a duster.
12-1 CLEANING THE SCREEN
Since the Projector screen is susceptible to damage, pay careful attention to its handling.
When cleaning, refrain from using water or volatile chemicals.
Projector adjustments are stored. Due to distortion or color deviation in the TEST mode, if an adjustment
is necessary, use the Remote Control to make adjustments.
CAUTION!
STOP
IMPORTANT!
CAUTION!
To Next Page
Loading...
