114
www.sauservice.com
● When performing work, be sure to turn power off. Working with power on can
cause electric shock and short circuit hazards.
● The Fluorescent Lamp, when it gets hot, can cause burn. Be very careful when
replacing the Fluorescent Lamp.
● Be sure to use lamps of the designated rating. Using lamps of undesignated rating
can cause a fire or malfunctioning.
● Be careful not to damage the wires. Damaged wires may cause electric shock or
short circuit or present a fire risk.
● To perform work safely and securely, be sure to prepare a step which is in a secure
and stable condition. Performing work without using the step can cause violent fall-
ing down accidents.
● Be careful when handling the plastic made parts. Failure to observe this may cause
injury due to damage or fragments resulting from damage.
Billboard Internal Fluorescent Light
● Turn the power off.
● Undo the 2 truss screws that hold the pop bracket in place, then remove the billboard pop.
14.
REPLACING THE FLUORESCENT LIGHTS AND LAMPS
Use a footstool to
perform this step.
FIG. 14 a
PHOTO 14 a
BILLBOARD POP
TRUSS SCREW (2), black
M4×8
CAUTION!
WARNING!
To Next Page
Loading...
