104
www.sauservice.com
REMOTE CONTROL LIGHT EMITTING PORTION
MODE (mode selection)
TEST (adjust/normal shift)
R. G. B. (color selection)
POSITION (to select the position)
ADJUST (adjustment)
WRITING (storing the data)
P (automatic color matching)
SET (to decide the selection)
PIC - ADJ (item selection)
RESET
SELECT (pattern selection)
When adjusting the Projector, direct the Remote Control's light emitting portion towards the Projector
Screen.
12-2 PROJECTOR ADJUSTMENT
In this product, set to INPUT LEVEL: 0.7 V and IMPEDANCE: 75Ω. Failure to
observe this can cause CRT membrane to burn or Shutdown device to function resulting
in power off.
The Projector's Connector Panel contains the Interface setting SW.
REMOTE CONTROL BUTTONS
SETTING THE INTERFACE
STOP
IMPORTANT!
To Next Page
Loading...
