26
www.sauservice.com
SECURING IN PLACE (ADJUSTER TUNING)
Make sure that all of the adjusters are in contact with the floor. If they are not, the cabi-
net can move and cause an accident.
● Transport the product to the installation position.
● Have all of the adjusters make contact with the floor. Adjust
the adjuster's height by using a wrench so that the machine
position is kept level.
When contacting the adjusters of the right and left fences
onto the floor, manually turn them.
● After making adjustment, fasten the adjuster nut upward and
secure the height of adjuster.
This product has 8 casters (4 for PTV Base, 4 for MAIN CABINET) and 6 Adjusters (4 for PTV Base, 2
for MAIN CABINET). (FIG. 6. 4 a) When the installation position is determined, cause the adjusters to
come into contact with the floor directly, make adjustments in a manner so that the casters will be raised
approximately 5 mm. from the floor and make sure that the machine position is level.
FIG. 6. 4 b ADJUSTER
FIG. 6. 4 d
Provide ventilation space for the ventilation opening.
FIG. 6. 4 c
Refer to this Fig. (Scale:1/100)
for the layout of the place of
installation.
FIG. 6. 4 a BOTTOM VIEW
CASTER
ADJUSTER
Fasten Upward.
ADJUSTER
Approx.5mm
ADJUSTER
CASTER
WARNING!
4
To Next Page
Loading...
