25
www.sauservice.com
● Tighten the 2 hexagon bolts on
each of the left and right brackets
of the main cabinet to affix the
cabinet.
● Attach the joint bracket uppers to the left and right sides of the joint between the main cabinet and the
PTV using 4 truss screws on each side to secure the joint. Arrange these so that the vertical holes corre
-
spond to the main cabinet and the horizontal holes correspond to the PTV.
If there is a gap between the main cabinet and the PTV, adjust the main cabinet or the adjuster on the
PTV base to close the gap before tightening the screws.
HEXAGON BOLT (2 ea), black t
w/spring washer, flat washer used
BRACKET
PHOTO 6. 3 h
JOINT BRACKET UPPER
ADJUSTER
TRUSS SCREW (4 ea), black
M5×20, flat washer used
PHOTO 6. 3 i
To Next Page
Loading...
