16
www.sauservice.com
6. ASSEMBLY AND INSTALLATION
● Perform assembly work by following the procedure herein stated. Failing to comply
with the instructions can cause electric shock hazard.
● Perform assembling as per this manual. Since this is a complex machine, erroneous
assembling can cause an electric shock, machine damage and or not functioning as
per specified performance.
● When assembling, be sure to use plural persons. Depending on the assembly work,
there are some cases in which working by one person alone can cause personal
injury or parts damage.
● Ensure that connectors are accurately connected. Incomplete connections can cause
electric shock hazard.
● Be careful not to damage the wires. Damaged wires may cause electric shock or
short circuit or present a fire risk.
● Do not carelessly push the PTV. Pushing the PTV carelessly can cause the PTV to
fall down.
● This work should be performed by the site maintenance individual or other skilled
professional. Performing work by non-technical personnel can cause a severe
accident such as electric shock. Failing to comply with this instruction can cause a
severe accident such as electric shock to the player during operation.
● Provide sufficient space so that assembling can be performed. Performing work in
places with narrow space or low ceiling may cause an accident and assembly work
to be difficult.
● To perform work safely and avoid serious accident such as the cabinet's falling
down, do not perform work in places where step-like grade differences, a ditch, or
slope exist.
● Do not use this product with connectors other than those that were connected and
used with the Game Board at the time of shipping. Do not carelessly connect wires
to connectors that were not used at the time of shipping, as this may cause overheat-
ing, smoke or fire damage.
● When handling plastic parts, use care. Do not give a shock or apply excessive load
to the fluorescent lamps and plastic parts. Failure to observe this can cause parts
damage, resulting in injury due to fragments, cracks and broken pieces.
● To perform work safely and securely, be sure to prepare a step which is in a secure
and stable condition. Performing work without using the step can cause violent
falling down accidents.
● Make sure that the GD cable connector is inserted parallel to the plug. Improper
insertion may cause damage to the connector and present a fire risk.
CAUTION!
WARNING!
To Next Page
Loading...
Need help?
General
