105
www.sauservice.com
The Projector may be subject to color deviations affected by earth magnetism, the building steel frames,
etc. When the Projector is initially installed or the Projector's installation position is changed, have the
color matching performed automatically.
● Keep pressing the P button (red) for approximately 3
seconds to have the ensuing movements performed
automatically.
When the green cross pattern movements are finished, similar detection
is performed sequentially in order of red and then blue cross movements.
After detecting by green, red and blue cross movements, the game mode
returns with the color deviation status being corrected.
● Although very rarely, the TRY AGAIN error display in red may appear. At this time, press the P
button (red) for approximately 3 seconds.
Even after the above operation is repeated, if the error condition still exists, then the display shifts to
PLEASE ADJ. In this case, the auto color matching function can not be used. Contact the place of
contact herein stated or where the product was purchased from.
● If the automatic color matching indicates an error, color matching can manually be performed. Refer
to CONVERGENCE ADJUSTMENT (manual color matching).
The Projector will shift to the color
deviation correction mode from the
game mode, with the green cross pattern
appearing on the screen.
The cross pattern moves up/down and right/
left to start the movement of searching the
correct screen position and inclination.
AUTOMATIC COLOR MATCHING
To Next Page
Loading...
