22
www.sauservice.com
ASSEMBLING THE CABINET
● Move the PTV to the back of the PTV base.
● Put the PTV on the PTV base. To do this, you will need at least 4 people to lift the PTV, and another per-
son to hold the PTV base to stop it from moving. Lower the PTV until it touches the supports. Take care
not to damage any wiring during this step.
● Attach the front panel using 4 truss screws. Take care
that you do not damage any wiring during this step.
You will need at least 5 people to
perform this step.
FIG. 6. 3 a
PHOTO 6. 3 a
TRUSS SCREW (4), black
M5×20, flat washer used
FRONT PANEL
PTV
PTV BASE
SUPPORT
3
To Next Page
Loading...
