23
www.sauservice.com
● Have 2 people lift the billboard and place it on the PTV. Lower the
billboard so that the two mask bracket uppers that were attached in step
2 fit into the 2 rectangular holes in the billboard base plate, and push the
billboard towards the PTV screen. The base plate of the billboard is then
fixed into place by fitting into the mask brackets.
● You will need a footstool to complete the
following step. Attach the billboard to the
PTV using 2 screws.
You will need 2 people to per-
form this step.
● Undo the single truss screw and remove the connector lid.
You will need a footstool to
perform this step.
SCREW (2) t
M5×16, w/flat & spring washers
BILLBOARD
PHOTO 6. 3 b
PHOTO 6. 3 c
CONNECTOR LID
TRUSS SCREW (1), black
M4×8
PHOTO 6. 3 d
To Next Page
Loading...
