95
5. Measuring Light Sources [Measurement Screen]
NOTE
●
Range L ( ): Select this when measuring small and low power ash
units (lower than 640lx·s), [Over] will appear if ash power is too high.
Select Range H.
●
Range H ( ): Select when measuring powerful ash units (brighter
than 580lx·s), [Under] will appear if ash power is too low. Select Range L.
6.
Press the Measuring Button ❺ .
Measurement will be taken with ash, and the light source values will be
displayed.
Because it affects measurement while measuring, the LCD backlight will dim. It is not a
defect.
Measurement in Cord (PC) Flash Mode is complete.
To Next Page
Loading...
