96
5. Measuring Light Sources [Measurement Screen]
CAUTION
●
Depending on the ash equipment used, the ash may be triggered when the
sync cord is connected to the Sync Terminal
⓬
or when operating the Power
Button
❸
. Because there is the possibility of burns or negative effects on
vision, please handle with care.
●
Do not trigger ash while skin or other objects are in contact with the ash
tube. Do not touch the ash tube after continuous ashes. (It may cause
burns.)
●
Do not trigger ash while near the eyes of people or animals. (It may
temporarily affect vision.)
●
The ash may be triggered suddenly. Because there is the possibility of
burns or negative effects on vision, please handle with care.
NOTICE
●
If the triggering voltage of the ash used is extremely low, the ash may not
trigger. In this care, use "5-3 Measurement in Cordless Flash Mode". (
P88)
●
When measuring ash bulbs, make sure the shutter sync speed is set to the
proper synchronization range of your camera.
NOTE
[Over] or [Under] will be displayed if the light source illumination is too bright or not bright
enough, or if the color temperature is out of the measurement range, when the Measuring
Button is pressed.
In this case, adjust the brightness or color temperature of light source, or switch the light
range. (
P99)
To Next Page
Loading...
