140
PREMIUM version
17.6. Messages
In the main menu, use the movement buttons
(up) and (down) to select the “Messages”
menu, and press the right display button to access it. Press to return to the main
menu without saving.
17.6.1. Activate push messages
The term push message refers to the letter symbol on the start
screen. You can activate/deactivate this message.
Select the “Push message” menu item using the movement buttons
(up) and (down). Use the channel selection button to acti-
vate the function
or deactivate it with
. Press the right display button to confirm.
17.6.2. Read push message
Use the movement buttons
(up) and (down) to scroll through the push messages. Each
push message has a consecutive number.
Message Meaning
Overload The drive has detected an overload.
Obstacle The drive has detected an obstacle.
Timer A switching action was not executed.
Not possible A manual action with the movement buttons
(up) and (down) is
not executed (e.g. end positions are not set).
Radio/wireless The commeo Multi Send cannot reach the displayed commeo device
via radio.
Sensor There is a sensor loss.
Wind The drive is in a “wind alarm” state.
Alarm The drive is in a general alarm state (not “wind alarm”).
17.6.3. Delete push messages
Note: All messages are always deleted together.
Select the “Delete” menu item using the movement buttons (up)
and
(down). Press the right display button to confirm. Press
the right display button again to confirm the query.
To Next Page
Loading...
