EN
93
General section (BASIS and PREMIUM)
10. Installation
10.1. Installation instructions
• Ensure that the control is not installed and operated close to any metallic surfaces or mag-
netic fields. Metallic surfaces or metal-coated glass panes within the transmission path can
significantly reduce the range.
• Radio systems that transmit on the same frequency can interfere with reception.
• Please note that the range of the radio signal is limited by legal provisions and structural
conditions.
10.2. Assembling the wall bracket
• Before assembling at the intended installation point, make sure
that the transmitter, drives and receivers work correctly.
• Secure the bracket to the wall using the two dowels and screws
provided. Ensure a distance of 69 mm between the holes.
To Next Page
Loading...
