SEW DRC2 - Page 116

116
Operating Instructions – Electronic Motor DRC.-..-SNI
8
Description of power section parameters
Parameters
Unit signature
index 9823.1,
9823.2, 9823.3,
9823.4, 9823.5
The parameter is used to indicate and enter the unit signature. This parameter is used
to assign a name to the power section so you can identify it in the hardware tree or in
other visualization elements.
Nominal unit
current (rms)
index 8361.0
The parameter indicates the nominal unit current (rms value).
• Unit: [mA]
Motor size
index 10079.9
The parameter indicates the size of the DRC drive unit.
Nominal motor
torque
index 9610.1
The parameter indicates the available continuous torque of the motor.
• Unit: [Nm]
Basic unit firmware
index 9701.30
The parameter indicates the part number of the firmware used in the power section.
Status of basic unit
firmware
index 9701.31
The parameter indicates the status of the firmware used in the power section.
Power section parameters \ display values \ gear unit data
Gear unit ratio
"numerator"
index 10079.3
The parameter indicates the gear ratio tooth numbers. This allows for representing the
gear ratio in whole numbers.
Gear unit ratio
"denominator"
index 10079.4
The parameter indicates the gear ratio tooth numbers. This allows for representing the
gear ratio in whole numbers.
Gear ratio The parameter indicates the gear ratio.
00
I