SharkRF openSPOT3 - D-STAR Transceiver

CrossmodesusingaD-STAR®transceiver
UsingaDMRnetwork
Afteryou'vesetupandactivatedtheDMRconnector,switchthemodemtoD-STAR®mode.
ThesourceDMRIDofyourcallsfromtheD-STAR®radiowillbesettotheIDassociatedwiththesourcecallsign.
Ifthere'snoIDassociated,thenthesourcecallsignwillbeparsedintoanumberandthiswillbeusedasthe
sourceDMRID.Ifitcan'tbeparsedintoanumber,thentheDefaultcrossmodesourceDMRIDwillbeused.You
cansetthistoyourDMRID.
ThecallsignofincomingDMRcallswillbesettothecallsignassociatedwiththeDMRID.Ifthere'snocallsign
associatedinthedatabase,thentheDefaultcallsignforcrossmodecallswillbeused.Ifit'snotset,thecallsign
willbethesourceDMRIDastext.
UsingaC4FMnetwork
Afteryou'vesetupandactivatedtheC4FMconnector,switchthemodemtoD-STAR®mode.OnlycallsinDN
(DigitalNarrow)modewillbeconvertedtoyourD-STAR®radio.Ifsomeonetransmitsinothermodesonthe
C4FMnetwork,youwillhearsilenceonyourD-STAR®radio.
Ifthere'sanincomingcallfromtheC4FMnetwork,andtheincomingcall'ssourcecallsigncanbefoundinthe
callsigndatabase,thentheopenSPOT3addsthecaller'snameandcountrycodetotheD-STAR®call'smessage.
UsinganNXDN®network
Afteryou'vesetupandactivatedtheNXDN®connector,switchthemodemtoD-STAR®mode.
AllD-STAR®callswillbesenttotheDefaultcrossmodedestinationIDontheNXDN®network.
ThesourceNXDN®IDofyourcallsfromtheD-STAR®radiowillbesettotheIDassociatedwiththesource
callsign.Ifthere'snoIDassociated,thenthesourcecallsignwillbeparsedintoanumberandthiswillbeusedas
thesourceNXDN®ID.Ifitcan'tbeparsedintoanumber,thentheDefaultcrossmodesourceIDwillbeused.
ThedefaultIDwillbeusediftheAlwaysusethisIDincrossmodesettingisenabledfortheDefaultcrossmode
sourceIDontheSettingspage,NXDN®settingssection.
ThecallsignofincomingNXDN®callswillbesettothecallsignassociatedwiththeNXDN®ID.Ifthere'sno
callsignassociatedinthedatabase,thentheDefaultcallsignforcrossmodecallswillbeused.Ifit'snotset,the
callsignwillbethesourceNXDN®IDastext.
D-STAR®transceiver
109