SharkRF openSPOT3 - Modem Page

Modempage
Youcanchangethemodemsettingsonthispage.
Ifyouchangethemodemmode,RXorTXfrequencyonthispage,thevalueswillbecopiedtothecurrently
activeconnector'ssettings.IfAdvancedmodeisturnedoff,bothRXandTXfrequencieswillbeautomaticallyset
tothesamevalue(theseparateRXandTXfrequencyfieldswillbehidden).
IftheIdlemodemmodeisactivatedthentheopenSPOT3'smodemwon'ttransmitandwillignoreallreceived
transmissions.
IncaseyouhavehalfdeviationenabledinyourC4FM/Fusion®radio(somemodelsdon'thavethissettingand
havehalfdeviationmodeenabledbydefault),usetheC4FMHalfDeviationmodemmode.
Frequency
TheModemreceivefrequencyoffsetsettingcanbeusedtocorrectthefrequencydifference(RXoffset)between
theopenSPOT3andtheusedtransmitter.ThissettingisonlyavailableifAdvancedmodeisenabled.
SettinganRXoffsetmaybeneededincaseothersreportthattransmissionscomingfromyourtransceiverhave
voicequalityissues.ThisshouldrarelyhappenastheopenSPOT3hasabuilt-in,factorycalibrated,extreme
accurateclockreference.YoucanalsousetheAutoCalspecialconnectortofindouttherequiredRXoffset
value,oryoucanusetheopenSPOT3'sbuilt-inlocalechoservicetofindouttheRXoffsetvalueyourselfby
listeningbackyourrecordedvoice.
CWID
YoucansetaCWIDwhichtheopenSPOT3willtransmitatthespecifiedintervalwiththespecifiedspeed.You
canuseletters,numbers,slash(/)andspacecharactersintheID.
Modempage
48