SharkRF openSPOT3 - System Configuration and Settings; Connectors, Modems, and Network

Connectorspage
InopenSPOT3terms,aconnectoristheprotocolwhichyouusetoconnecttheopenSPOT3toaserver.
TheeasiestwaytochoosewhichconnectortoselectisusingtheQuickSetup.
YoucanactivateaconnectorbyselectingitfromtheEditconnectorlistandclickingontheSwitchtoselected
button.Youcaneditaconnector'ssettingsbyselectingitfromtheEditconnectorlist.Don'tforgettoclickon
theSavebuttonafterchangingaconnector'ssettings.
Notesonconnectors
Eachconnectorhasit'sownassignedRX/TXfrequenciesandmodemmodes.Thesefrequenciesandmodem
modeswillbeusedwhentheconnectorbecomesactivated.
SomeconnectorshaveAddserverandRemovebuttons.Thesecanbeusedtoaddandremovecustomservers
intheserverlist.Notethatthesecustomserversarestoredinthebrowser'slocalstorage(theywon'tshowup
usinganotherbrowser).
SomeconnectorshaveaKeepaliveintervalsetting.ThismeanstheserverrequirestheopenSPOT3to
periodicallysendkeepalivemessagestotheserver.TheRXtimeoutsettingspecifiesthetimeafterthelast
receivedvalidnetworkpacketneededfortheopenSPOT3toconsidertheconnectionisdeadanditshould
reconnect.IftheopenSPOT3frequentlydisconnectsfromtheserver,tryincreasingtheRXtimeout.
IfaconnectorhasboththeKeepaliveintervalandRXtimeoutsettings,thenmakesuretheRXtimeoutissetto
agreatervaluethanthe*Keepaliveinterval.
TheConnectretryintervalsetsthedelaybetweenserverconnectretries.
Asageneralrule,trytouseaservernearesttoyourlocationtoavoidpacketlossandhighlatency.
PleaseseetheConnectorssectionformoreinformationabouteachconnector.
Generalconnectorsettings
Connectorspage
46