EasyManua.ls Logo

SharkRF openSPOT3 - Page 45

SharkRF openSPOT3
131 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TheRSSIgraphshowsreceivesignalstrengthfromthemodem.TheBERgraphshowsreceivedBitErrorRatio
duringacall.BERiscalculatedalsoforpacketsreceivedfromthenetwork,notjustfromthemodem.The
dejitterqueuegraph(onlyshownifAdvancedmodeisenabled)showsthenumberofpacketswaitinginthe
dejitterqueue.
Aboutthedejitterqueue
Allpacketsreceivedfromthenetworkwillfirstgotothisqueuetoeliminatenetworkjitter.
Ifthedejitterqueuelengthistooshort,thegraph'slinecantouchzeroduringacallandtheaudiocanstopfor
amomentasthemodemrunsoutofframestotransmit.
Ifthequeue'slengthistoolong,thedelaycanbeuncomfortablyhigh.
Youcanusethisgraphtosetaproperdejitterqueuelength.Thereshouldbeatleastafewpacketsinthe
dejitterqueuewhenreceivingacallfromthenetwork.YoucansetthedejitterqueuelengthontheNetwork
page(thesettingonlyshowsupifAdvancedmodeisenabled).Asageneralrule,ifyouhaveagoodnetwork
connectiontotheselectedconnector'sserver,setdejitterqueuelengthto500ms,andifyouhavea3G/4G
internetconnectionorvoicestuttersalot,trysettingthelengthtoatleast1000ms.
Statuspage
45

Related product manuals